R&S SMA100A - 9 HP8373 Emulation Mode; General; GPIB Functions; Commands

HP8373 emulation mode
1GP71_0E 97 Rohde & Schwarz
9 HP8373 emulation mode
General
In this language emulation mode, the emulation software in the SM* emulates
the SCPI-compatible language, implemented in Agilents’s signal generators of
type
o HP83711A / B
o HP83712A / B
o HP83730A
o HP83731A / B
o HP83732A
The emulation software is supported on signal generators of type
o SMF100
The signal generator HP8373x also supports a HP8673 compatible Pre-
SCPI-language. This emulation is not available so far.
The emulation software simulates the HP8373 data model in the execution unit
and transfers most of the HP8373 parameters into the SM* database.
SM*
database
SM*
remote control
interface
SM*
frontpanel
SM*
hardware
Figure 6: HP8373 emulation model
Those HP8373 functions and parameters, having no direct equivalent SM*
function and parameter, are not supported by this emulation so far.
GPIB functions
Commands
The following table shows the commands, supported by the HP8373.