R&S SMA100A - Calibration Subsystem

HP8360 emulation mode
1GP71_0E 81 Rohde & Schwarz
Status Command / Function / Remark / Limitation
AM:SOURce value
Select / Query the signal source of the modulation.
Value:
INTernal | EXTernal
Default:
EXTernal
Remark:
INTernal, EXTernal are not supported
LF1 corresponds to INTernal
EXT1 corresponds to EXTernal
AM:STATe value
Set / Query the (activation) state of the modulation.
Value:
ON | OFF | 1 | 0
Default:
OFF
AM:TYPE value
Table 70: AM subsystem
• CALibration Subsystem
Status Command / Function / Remark / Limitation
CALibration:AM:AUTO value
CALibration:AM[:EXECute]
CALibration:PEAKing:AUTO value
CALibration:PEAKing[:EXECute]
CALibration:PMETer:DETector:INITiate? value
CALibration:PMETer:DETector:NEXT? value
CALibration:PMETer:FLATness:INITiate? value
CALibration:PMETer:FLATness:NEXT? value
CALibration:SPAN:AUTO value
CALibration:SPAN[:EXECute]
CALibration:TRACK
CALibration:CORRection:ARRay{0 | 1} value
CALibration:CORRection:FLATness value
CALibration:CORRection:FLATness:POINts? value
CALibration:CORRection:SOURce{0 | 1} value