R&S SMA100A - GPIB Functions; Commands; Additional

HP8657 emulation mode
1GP71_0E 144 Rohde & Schwarz
As an important fact, the HP8657 network analyzer language does not support
query commands.
GPIB functions
The following table shows the GPIB functions, supported by the HP8657.
Status Command Function / Remark / Limitation
DCL
Device clear.
Remark:
SDC applies an IP command to the emulation software
and presets the instrument.
GTL Goto local mode.
LLO Local lockout.
REN Goto remote mode.
SDC
Selective device clear.
Remark:
SDC applies an IP command to the emulation software
and presets the instrument.
Table 141: GPIB functions
Commands
The following table shows the commands, supported by the HP8657.
• Additional
Status Command / Function / Remark / Limitation
EX
Return to SCPI mode.
Remark:
This command has been added to the HP8657 command set.
IP
Preset instrument.
Remark:
SM* always presets to the HP8657 factory defaults.
o 100 MHz frequency
o 10 MHz frequency increment / decrement
o 0 ° frequency phase
o – 143.5 dBm amplitude
o 10 dB amplitude increment / decrement
o 0 dB amplitude offset
o Active mode
o RF output on