R&S SMA100A - Commands; Additional; Frequency; Amplitude

HP8662 emulation mode
1GP71_0E 151 Rohde & Schwarz
Status Command Function / Remark / Limitation
DCL Device clear.
GET Goup execute trigger.
GTL Goto local mode.
LLO Local lockout.
REN Goto remote mode.
SDC Selective device clear.
SPD Serial-Poll disable.
SPE Serial-Poll enable.
SRQ Request service.
Table 148: HP8662 GPIB functions
Commands
The following table shows the commands, supported by the HP8662.
• Additional
Status Command / Function / Remark / Limitation
EX
Return to SCPI mode.
Remark:
This command has been added to the HP8662 command set.
Table 149: Additional commands
• Frequency
Status Command / Function / Remark / Limitation
FR value
Set fixed frequency.
Value:
Fmin … Fmax in {HZ | KZ | MZ | GZ} | UP | DN
Default:
100.0 MZ
Remark:
Center frequency in rf sweep is also set with this command.
Table 150: Frequency commands
• Amplitude
Status Command / Function / Remark / Limitation