R&S SMA100A - Sweep Subsystem; System Subsystem

HP8643 emulation mode
1GP71_0E 128 Rohde & Schwarz
Table 122: STATUS subsystem commands
• SWEep Subsystem
Status Command / Function / Remark / Limitation
SWEep[:FREQuency]:GENeration value
SWEep[:FREQuency]:MODE value
Set / Query sweep mode.
Value:
AUTO | MANual
Default:
AUTO
SWEep[:FREQuency]:SPACing value
Set / Query sweep spacing.
Value:
LINear | LOGarithmic
Default:
LINear
SWEep[:FREQuency]:TIME value
Set / Query the (total) sweep time.
Value:
value [S | MS | US | NS] | UP | DOWN | MINimum | MAXimum
Default:
1.0 S
Remark:
Only 1-2-5-10 items are valid.
sweep time is divided into dwell time and count.
SWEep[:FREQuency]:TIME:MODE?
Query the sweep time mode informations.
SWEep[:FREQuency]:TIME:STEP[:INCRement]?
Query the sweep time step informations.
Table 123: SWEep subsystem commands
• SYSTem Subsystem
Status Command / Function / Remark / Limitation
SYSTem:ERRor?
Query and clear the oldest error.
SYSTem:STATe:CALL
SYSTem:SECurity value
Table 124: SYSTEM subsystem commands