R&S SMA100A - Automatic Level Control; Carrier

HP8373 emulation mode
1GP71_0E 99 Rohde & Schwarz
Status Command / Function / Remark / Limitation
*SAV value
Save an instrument setup.
Value:
0 … 9
*SRE value
Set / Query the bits of the service request enable register.
Value:
0 … 191
*STB?
Query the bits of the status byte.
*TST?
Performs a self test and returns result.
Remark:
0 is return in any case, indicating no error.
*WAI
Wait until pending operations have taken place.
Table 91: Common commands
• Automatic Level Control
Status Command / Function / Remark / Limitation
[SOURce[1]:]POWer:ALC:PMETer[:LEVel][:AMPLitude] value
[SOURce[1]:]POWer:ALC:PMETer[:LEVel]:STEP[:INCRement] value
[SOURce[1]:]POWer:ALC:SOURce value
Set / Query type of leveling for output power automatic leveling
Value:
INTernal | DIODe | PMETer
Default:
INTernal
Table 92: Automatic level control commands
• Carrier
Status Command / Function / Remark / Limitation
[SOURce[1]:]FREQuency[:CW | :FIXed] value
Set / Query the rf carrier frequency.
Value:
Fmin … FMax [HZ | KHZ | MHZ | MHZ | GHZ] | UP | DOWN | MINimum | MAXimum
| DEFault
Default:
3.0 GHZ
Remark:
UP, DOWN, MINimum, MAXimum, DEFault are not supported.