R&S SMA100A - Initialize Subsystem

HP8643 emulation mode
1GP71_0E 119 Rohde & Schwarz
Status Command / Function / Remark / Limitation
[:SOURce:]FREQuency:SPAN value
Set / Query the rf carrier sweep frequency span.
Value:
value HZ | KHZ | MHZ | MAHZ | GHZ] | UP | DOWN | MINimum | MAXimum
Default:
freqmax - freqmin
[SOURce:]FREQuency:SPAN:STEP[:INCRement] value
Alias to FREQuency[:CW]:STEP[:INCRement] value
[:SOURce:]FREQuency:MANual value
Set / Query the actual rf carrier frequency in stepped sweep.
Value:
value [HZ | KHZ | MHZ | MAHZ | GHZ] | MINimum | MAXimum
Default:
freqmin
[:SOURce:]FREQuency:OFFSet value
Set / Query the rf carrier frequency offset.
Value:
value [HZ | KHZ | MHZ | MAHZ | GHZ] | MINimum | MAXimum
Default:
0.0 HZ
[:SOURce:]FREQuency:MULTiplier value
[:SOURce:]FREQuency:SYNThesis value
[:SOURce:]FREQuency:SYNThesis:AUTO value
[:SOURce:]FREQuency:MODE value
Set / Query the rf carrier frequency operation mode.
Value:
CW | SWEep
Default:
CW
[:SOURce:]FREQuency:INSTantaneous?
Table 111: FREQuency subsystem commands
• INITialize Subsystem
Status Command / Function / Remark / Limitation
INITialize[:IMMediate]
Starts a single or continuous sweep.
INITialize:ABORt
Terminates a sweep.