R&S SMA100A - Frequency Markers

HP8340 emulation mode
1GP71_0E 60 Rohde & Schwarz
freqmin … freqmax HZ | KZ | MZ | GZ
Default:
0.5 * (freqmin + freqmax)
Remark:
Acts like CW[value]
Frontpanel knob and step keys are not linked to cw frequency and cw frequency
resolution.
Commands RB[value] and UP/DN are not linked to cw frequency and cw frequency
resolution.
Table 52: Swept / CW Frequency Selection commands
• Frequency Markers
Status Command / Function / Remark / Limitation
M1[value]
Turn on marker 1, optionally set marker frequency.
Value:
freqmin … freqmax HZ | KZ | MZ | GZ
Default:
0.5 * (freqmin + freqmax)
Remark:
There is no signal output on auxiliary i/o.
M2[value]
Turn on marker 2, optionally set marker frequency.
Value:
freqmin … freqmax HZ | KZ | MZ | GZ
Default:
0.5 * (freqmin + freqmax)
Remark:
There is no signal output on auxiliary i/o.
M3[value]
Turn on marker 3, optionally set marker frequency.
Value:
freqmin … freqmax HZ | KZ | MZ | GZ
Default:
0.5 * (freqmin + freqmax)
Remark:
There is no signal output on auxiliary i/o.
M4[value]
Turn on marker 4, optionally set marker frequency.
Value:
freqmin … freqmax HZ | KZ | MZ | GZ
Default:
0.5 * (freqmin + freqmax)