R&S SMA100A - Calibration Subsystem; Display Subsystem

HP8643 emulation mode
1GP71_0E 116 Rohde & Schwarz
Status Command / Function / Remark / Limitation
{AMPLitude | POWer}:SOURce:STATe value
Set / Query the (activation) state of the rf output.
Value:
ON | OFF | 1 | 0
Default:
OFF
{AMPLitude | POWer}:SOURce:ULIMit value
{AMPLitude | POWer}:SOURce:UNIT value
Set / Query the rf carrier’s power level unit.
Value:
DBM | DBMW | DBUV | V
Default:
DBM
Table 107: AMPLitude subsystem commands
• CALibration Subsystem
Status Command / Function / Remark / Limitation
CALibration:ALL?
CALibration:AMPLitude:STATe value
Table 108: CALibration subsystem commands
• DISPlay Subsystem
Status Command / Function / Remark / Limitation
DISPlay:STATe value
Set / Query the activation state of the front panel
Value:
ON | OFF | 1 | 0
Default:
ON
Remark:
OFF enables the screen saver, ON disables the screen saver.
DISPlay:ANNotation[:ALL] value
DISPlay:ANNotation:AMPLitude value
DISPlay:ANNotation:FREQuency value
DISPlay:ANNotation:LFSource value
DISPlay:ANNotation:MODulation value
DISPlay:RADix value
Table 109: DISPlay subsystem commands