R&S SMA100A - Page 115

HP8643 emulation mode
1GP71_0E 115 Rohde & Schwarz
Status Command / Function / Remark / Limitation
{AMPLitude | POWer}:SOURce[:LEVel] value
Set / Query the rf carrier’s power level in EMF.
Value:
Value [DBM | DBMW | DBUV |V | MV | UV] | UP | DOWN | MINimum | MAXimum
Default:
-140 DBM
{AMPLitude | POWer}:SOURce[:LEVel]:STEP[:INCRement] value
Set / Query the rf carrier’s power level step size in EMF.
Value:
Value [DB | V | MV | UV] | MINimum | MAXimum
Default:
10.0 DB
{AMPLitude | POWer}:SOURce[:LEVel]:STEP:UNIT value
Set / Query the rf carrier’s power level step unit.
Value:
DB | V
Default:
DB
{AMPLitude | POWer}:SOURce:ALC:BANDwidth:AUTO value
{AMPLitude | POWer}:SOURce:ATTenuation value
Set / Query the output attenuator.
Value:
value DB
Default:
0.0 DB / AUTO ON
{AMPLitude | POWer}:SOURce:ATTenuation:AUTO value
Set / Query the (activation) state of automatic attenuation mode.
Value:
ON | OFF | 1 | 0
Default:
OFF
{AMPLitude | POWer}:SOURce:ATTenuation:STEP[:INCRement]?
{AMPLitude | POWer}:SOURce:GAIN value
Set / Query the rf carrier’s gain (offset).
Value:
value [DB] | MINimum | MAXimum
Default:
0.0 DB
{AMPLitude | POWer}:SOURce:MUTing value