R&S SMA100A - Page 155

HP8662 emulation mode
1GP71_0E 155 Rohde & Schwarz
FA value
Set rf sweep start frequency.
Value:
100.0 KHz … 2560.0 MHz in {HZ | KZ | MZ | GZ} | UP | DN
Default:
?
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
FB value
Set rf sweep stop frequency.
Value:
100.0 KHz … 2560.0 MHz in {HZ | KZ | MZ | GZ} | UP | DN
Default:
?
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
FS value
Set rf sweep frequency span.
Value:
0.2 Hz … 2560.0 MHz in {HZ | KZ | MZ | GZ} | UP | DN
Default:
?
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
N1
Set sweep steps to 100 and sweep spacing to linear.
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
N2
Set sweep steps to 1000 and sweep spacing to linear.
Remark:
Rf carrier sweep is supported.
Modulation sweep (Lf sweep) is not supported so far.
Special Functions 40 and 41 have no effect.
N3 value