R&S SMA100A - Page 49

AN680XX emulation mode
1GP71_0E 49 Rohde & Schwarz
Status Command / Function / Remark / Limitation
[:SOURce:]POWer:SPAN value
Set / Query the power level span for the sweep mode SWEep2.
Value:
powermin … powermax [DBM]
Default:
powermax – powermin
[:SOURce:]POWer:SPAN:FULL
Set the power level span for the sweep mode SWEep2 to powermax – powermin.
[:SOURce:]POWer:STARt value
Set / Query the start power level for the sweep mode SWEep2.
Value:
powermin … powermax [DBM | MIN
Default:
powermin
[:SOURce:]POWer:STOP value
Set / Query the stop power level for the sweep mode SWEep2.
Value:
powermin … powermax [DBM | MAX
Default:
powermax
SWEep<n>[:FREQuency]:STEP value
Set / Query the step size for frequency sweep.
Value:
stepmin … stepmax [HZ | KHZ | MHZ | GHZ] | MIN | MAX
Default:
0.0001 * (freqmax - freqmin)
Remark:
SWEep[1] is used for frequency sweep, SWEep2 is used for power sweep.
[:SOURce:]SWEep<n>:DIRection value
Select / Query the sweep direction.
Value:
UP | DOWN
Default:
UP
Remark:
STARt and STOP are exchanged if necessary.
SWEep[1] is used for frequency sweep, SWEep2 is used for power sweep.