R&S SMA100A - Page 93

HP8360 emulation mode
1GP71_0E 93 Rohde & Schwarz
Status Command / Function / Remark / Limitation
SWEep:DWELl value
Set / Query the fdwell time (in sweep mode).
Value:
num [S | MS | US] | MAXimum | MINimum
Pmin dBm _ num _ Pmax dBm
Default:
100.0 US
Remark:
MAXimum, MINimum are not supported.
Only frequency sweep is supported.
SWEep:DWELl:AUTO value
SWEep:GENeration value
SWEep:MANual:POINt value
SWEep:MANual[:RELative] value
SWEep:MARKer:STATe value
SWEep:MARKer:XFER
SWEep:MODE value
Set / Query the sweep operation mode.
Value:
AUTO | MANual
Default:
AUTO
SWEep:POINts value
Set / Query the number of points in a stepped sweep.
Value:
num | MAXimum | MINimum
1 _ num _ tbd
Default:
11
Remark:
MAXimum, MINimum are not supported.
Only frequency sweep is supported.