RL78/F13, F14 CHAPTER 16 SERIAL INTERFACE IICA
R01UH0368EJ0210 Rev.2.10 1023
Dec 10, 2015
16.3.2 IICA control register 00 (IICCTL00)
This register is used to enable/stop I
2
C operations, set wait timing, and set other I
2
C operations.
The IICCTL00 register can be set by a 1-bit or 8-bit memory manipulation instruction. However, set the SPIE0,
WTIM0, and ACKE0 bits while IICE0 = 0 or during the wait period. These bits can be set at the same time when the
IICE0 bit is set from “0” to “1”.
Reset signal generation clears this register to 00H.
To Next Page
Loading...
