USB2.0/SD Slot Type A
SM 2-81 D023/D025
Installation
12. Attach the bracket [A] with its two hooks [B] as shown above ( x 1: M3x6).
13. Put the USB cable [A] through the cutout [B] of the left frame cover.
14. Attach the scanner left cover [C] to the mainframe, and then connect the USB cable [A]
to USB-A (front side) as shown above.
Make sure that the USB cable is inserted in USB-A (front side).
15. Reinstall the rear cover ( x 8).
16. Plug in and turn on the mainframe.
17. Enter the SP mode, and then change the setting of SP1013-001 from “0” to “1”.
To Next Page
Loading...
