Ricoh D025 - Settings for @Remote Service

Copier Installation
SM 2-13 D023/D025
Installation
double
counting
doubled for A3/11" x 17" paper.
When you have to change this
setting, contact your supervisor.
counting
Service Tel.
No. Setting
SP5-812-001
through 004
5812-002 programs the service
station fax number. The number is
printed on the counter list when the
meter charge mode is selected.
This lets the user fax the counter
data to the service station.
Settings for @Remote Service
 Prepare and check the following check points before you visit the customer site.
For details, ask the @Remote key person.
Check points before making @Remote settings
1. The setting of SP5816-201 in the mainframe must be "0".
2. Device ID2 (SP5811-003) must be correctly programmed.
 6 spaces must be put between the 3-digit prefix and the following 8-digit number
(e.g. xxx______xxxxxxxx).
 ID2 (SP5811-003) and the serial number (SP5811-001) must be the same (e.g.
ID2: A01______23456789 = serial No. A0123456789)
3. The following settings must be correctly programmed.
 Proxy server IP address (SP5816-063)
 Proxy server Port number (SP5816-064)
 Proxy User ID (SP5816-065)
 Proxy Password (SP5816-066)
4. Get a Request Number
Execute the @Remote Settings
1. Enter the SP mode.
2. Input the Request number which you have obtained from @Remote Center GUI, and
then enter [OK] with SP5816-202.
3. Confirm the Request number, and then click [EXECUTE] with SP5816-203.
4. Check the confirmation result with SP5816-204.