Ricoh D025 - Color Registration; Line Position Adjustment

Image Adjustment
SM 4-9 D023/D025
Replacement
&
Adjustment
4.3.5 COLOR REGISTRATION
Line Position Adjustment
The automatic line position adjustment usually is done for a specified condition to get the
best color prints.
Do the following if color registration shifts:
 Do “Auto Color Registration” as follows to do the forced line position adjustment.
1. First do SP2-111-3.
2. Then do SP2-111-1.
To check if SP 2-111-1 was successful, watch the screen during the process. A
message is displayed at the end. Also, you can check the result with SP 2-194-10
to -12.
 You should also do the line position adjustment at these times:
 After you transport or move the machine (you should do the forced line position
adjustment if you install the machine at the user location.) if the machine is
pre-installed at the workshop and moved to the user location,
 When you open the drum positioning plate
 When you remove or replace the motors, clutches, and/or gears related to the
drum/development/transfer sections
 When you remove or replace the image transfer belt, image transfer belt unit or
laser optical housing unit