Service Program Mode
D023/D025 5-4 SM
4. Use the center touch-panel buttons to scroll to the number and title of the item that you
want to set and press it. The small entry box on the right activates and shows the
below default or the current settings.
Refer to the Service Tables for the range of allowed settings.
1. Do this procedure to enter a setting:
Press to toggle between plus and minus and use the keypad to enter the
appropriate number. The number you enter writes over the previous setting.
Press to enter the setting. (The value is not registered if you enter a number
that is out of range.)
Press “Yes” when you are prompted to complete the selection.
2. If you need to perform a test print, press Copy Window to open the copy window and
select the settings for the test print. Press Start C and then press SP Mode
(highlighted) in the copy window to return to the SP mode display.
3. Press Exit two times to return to the copy window when you are finished.
Exiting Service Mode
Press the Exit key on the touch-panel.
Service Mode Lock/Unlock
At locations where the machine contains sensitive data, the customer engineer cannot
operate the machine until the Administrator turns the service mode lock off. This function
makes sure that work on the machine is always done with the permission of the
Administrator.
1. If you cannot go into the SP mode, ask the Administrator to log in with the User Tool
and then set “Service Mode Lock” to OFF after he or she logs in:
To Next Page
Loading...
