Service Program Mode
SM 5-5 D023/D025
System
Maintenance
Reference
User Tools > System Settings > Administrator Tools > Service Mode Lock > OFF
This unlocks the machine and lets you get access to all the SP codes.
The CE can service the machine and turn the machine off and on. It is not
necessary to ask the Administrator to log in again each time the machine is turned
on.
2. Go into the SP mode and set SP5169 to “1” if you must use the printer bit switches.
3. After machine servicing is completed:
Change SP5169 from “1” to “0”.
Turn the machine off and on. Tell the administrator that you have completed
servicing the machine.
The Administrator will then set the “Service Mode Lock” to ON.
5.1.4 REMARKS
Display on the Control Panel Screen
The maximum number of characters which can show on the control panel screen is limited
to 30 characters. For this reason, some of the SP modes shown on the screen need to be
abbreviated. The following are abbreviations used for the SP modes for which the full
description is over 20 characters.
Paper Weight
Thin paper: 60 g/m
2
Plain Paper: 60-90 g/m
2
, 16-24lb.
Middle Thick: 91-105 g/m
2
, 24-28lb.
Thick Paper 1: 106-169 g/m
2
, 28.5-44.9lb.
Thick Paper 2: 170-220 g/m
2
, 45-58lb.
Thick Paper 3: 221-256 g/m
2,
59lb-68lb
Paper Type
N: Normal paper
MTH: Middle thick paper
TH: Thick paper
Paper Feed Station
P: Paper tray
B: By-pass table
Color Mode [Color]
[K]: Black in B&W mode
[Y], [M], or [C]: Yellow, Magenta, or Cyan in Full Color mode
[YMC]: Only for Yellow, Magenta, and Cyan
To Next Page
Loading...
