System Service Mode
SM Appendix 8-297 D023/D025
Appendix
SP Mode
Tables
SP6-XXX (Peripherals)
6006 [ADF Adj.] ADF Adjustment
Adjusts the side-to-side and leading registration of originals with the ARDF.
001 Side-to-Side Registration
002
Side-to-Side Registration
(2nd side)
[-3.0 to 3.0 / 0 / 0.1 mm/step ]
003
Leading Edge
Registration
*ENG
[-5.0 to 5.0 / 0 / 0.1 mm/step ]
Adjusts the amount of paper buckle to correct original skew for the front and
rear sides.
005 Buckle: Duplex Front
[-3.0 to 3.0 / 0 / 0.1 mm/step ]
006 Buckle: Duplex Rear
*ENG
[-2.5 to 2.5 / 0 / 0.1 mm/step ]
Adjusts the erase margin at the original trailing edge.
007 Rear Edge Erase *ENG
[-10 to 10 / 0 / 0.1 mm/step ]
[ADF Input Check]
6007
Displays the signals received from the sensors and switches of the ARDF. Only
Bit 0 is used for ADF input check ( “Iutput Check Table” in this section").
[ADF Output Check]
6008
Activates the electrical components for functional check.
It is not possible to activate more than one component at the same time (
“Output Check Table” in this section")
To Next Page
Loading...
