Ricoh D025 - Rear Scanner Wire; Reinstalling the Rear Scanner Wire

Scanner Unit
D023/D025 4-36 SM
4.5.11 REAR SCANNER WIRE
1. Exposure glass ( p.4-20 "Exposure Glass")
2. Scanner left stay ( p.4-26 "Front Scanner Wire")
3. Scanner rear frame [A] ( x 9, ground screw x 2,  x All)
4. Follow the steps 3 through 5 in the “” Section. You can remove the rear scanner wire
with the same manner for replacing the front scanner wire.
Reinstalling the Rear Scanner Wire
1. Position the center ball [A] in the middle of the forked holder.
2. Pass the left end (with the ball) [B] through the drive pulley notch. Pass the right end
(with the ring) [C] through the drive pulley hole.
3. Wind the left end [B] clockwise (shown from the machine’s front) five times. Wind the
right end [C] counterclockwise three times.
 The two red marks [D] come together when you do this. Attach the wire to the
pulley with tape. This lets you easily handle the assembly at the time of
installation.
4. Install the drive pulley on the shaft.