D023/D025 2-40 SM
Installing the DF Handle
1. Attach the holder [A] to the scanner right cover (Tapping Screw - M3x12: x 2).
At first, secure the screw at the rear side (away from the operation panel)
temporarily and then at the front side temporarily. After that, secure them fully.
2. Install the bushing: 6MM [B] in the inside of the handle unit.
3. Attach the handle unit to the stud bracket on the left side of the ADF.
4. In the outside of the handle unit, install the bushing - M6 [C] first, and then the spacer
[D].
To Next Page
Loading...
