Ricoh D025 - Switching on and Setting up Save Debug Log

Using the Debug Log
D023/D025 5-38 SM
5.10.2 SWITCHING ON AND SETTING UP SAVE DEBUG LOG
The debug information cannot be saved until the “Save Debug Log” function has been
switched on and a target has been selected.
1. Enter the SP mode and switch the Save Debug Log feature on.
 Press S then use the 10-key pad to enter .
 Press and hold down D for more than 3 seconds.
 Touch “Copy SP”.
 On the LCD panel, open SP5857.
2. Under “5857 Save Debug Log”, touch “1 On/Off”.
3. On the control panel keypad, press “1”. Then press . This switches the Save Debug
Log feature on.
 The default setting is “0” (OFF). This feature must be switched on in order for
the debug information to be saved.
4. Select the target destination where the debug information will be saved. Under “5857
Save Debug Log”, touch “2 Target”, enter “2” with the operation panel key to select the
hard disk as the target destination. Then press .
 Select “3 SD Card” to save the debug information directly to the SD card if it is
inserted in the service slot.