Ricoh D025 - System Maintenance Reference; Service Program Mode; Enabling and Disabling Service Program Mode; Entering SP Mode

Service Program Mode
SM 5-1 D023/D025
System
Maintenance
Reference
5. SYSTEM MAINTENANCE REFERENCE
5.1 SERVICE PROGRAM MODE
 Make sure that the data-in LED () is not on before you go into the SP mode. This
LED indicates that some data is coming to the machine. When the LED is on, wait
for the copier to process the data.
5.1.1 SP TABLES
See "Appendices" for the following information:
 System SP Tables
 Printer SP Tables
 Scanner SP Tables
5.1.2 ENABLING AND DISABLING SERVICE PROGRAM MODE
 The Service Program Mode is for use by service representatives only. If this mode
is used by anyone other than service representatives for any reason, data might
be deleted or settings might be changed. In such case, product quality cannot be
guaranteed any more.
Entering SP Mode
1. Press the "Clear Mode" key (D).
2. Use keypad to enter "107" ().
3. Hold down "Clear/Stop" (D) for 3 seconds at least.
4. Enter the Service Mode.
Exiting SP Mode
1. Press "Exit" on the LCD twice to return to the copy window.