Ricoh D025 - For Installing the Tray Heater in D387

Anti-Condensation Heater Type A
SM 2-91 D023/D025
Installation
10. Connect the harness [K] to the connector [L] of the tray heater.
11. Route the harness [K] as shown and clamp it with four clamps (= x 4).
12. Connect the harness [K] to the connector [M] of the mainframe.
13. Reassemble the mainframe and optional LCT.
14. Reassemble the mainframe and optional paper feed unit.
15. Attach the on/standby decal [N] to the right-hand side of the main power switch.
For Installing the Tray Heater in D387
1. Remove the rear cover of the mainframe ( step 1 in For Installing the Tray Heater in
D321).
2. Pull out the tray in the optional paper tray.
3. Install the tray heater [A] in the optional paper tray ( x 1).