Ricoh D025 - Page 140

D023/D025 2-92 SM
4. Remove the two securing brackets [B] ( x 1 each), and then the rear cover [C] of the
optional paper tray ( x 2).
5. Remove the harness cover bracket [D] ( x 1).
6. Pull out tray 2 from the mainframe.
7. Replace the shoulder screw [E] with the washer screw [F], using securing bracket [G]
( x 1).
1. Connect the harness [H] to the connector [I] of the tray heater.
2. Route the harness [H] as shown and clamp it with four clamps ( x 4).