D023/D025 2-12 SM
1. Attach the manual pocket [A] to the left side of the copier (snap rivet x 2).
2. If a finisher has been installed, attach the manual pocket [B] to the rear side of the
finisher (snap rivet x 2).
Initialize the Developer
1. Plug in the machine.
2. Make sure that the platen or ARDF is closed and the main power is turned off.
3. Turn the main power switch on. The machine automatically starts the initialization
procedure. The Start button LED (C) turns green when this procedure has finished.
4. Make copies of image samples (text, photo, and text/photo modes).
5. Do the Automatic Color Calibration process (ACC) as follows:
1). Print the ACC test pattern (User tools > Maintenance > ACC > Start).
2). Put the printout on the exposure glass.
3). Put 10 sheets of white paper on top of the test chart.
4). Close the ARDF or the platen cover.
5). Press “Start Scanning” on the LCD panel. The machine starts the ACC.
6. Check that the sample image has been copied normally.
Settings Relevant to the Service Contract
Change the necessary settings for the following SP modes if the customer has made a
service contract.
You must select one of the counter methods (developments/prints) in accordance
with the contract ( SP5-045-001).
Item SP No. Function Default
Counting
method
SP5-045-001
Specifies if the counting method
used in meter charge mode is
based on developments or prints.
NOTE: You can set this one time
only. You cannot change the setting
after you have set it for the first
time.
“0”:
Developments
A3/11" x 17" SP5-104-001 Specifies whether the counter is “No”: Single
To Next Page
Loading...
