Image Creation
SM 4-57 D023/D025
Replacement
&
Adjustment
6. Release the toner supply tube [C].
7. Remove the toner pump unit [A] ( x 2)
Make sure that a sheet of paper is attached to the frame of the rear side. The picture
on the left shows a sheet of paper that is correctly set, but the picture on the right
shows a sheet of paper that is not correctly set. This sheet of paper prevents toner and
screws from falling into the laser optics housing unit through cutouts.
1. Slowly remove the toner supply tube [A] from the toner pump unit by pulling the tube
To Next Page
Loading...
