Ricoh D025 - Page 539

SC Tables
SM Appendix 3-87 D023/D025
Appendix
Service Call
Conditions
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
876
CTL
D
Log Data Error
An error was detected in the handling of the log data at power on or
during machine operation. This can be caused by switching the
machine off while it is operating.
-001
Log Data Error 1
 Damaged log data file in the HDD
Initialize the HDD with SP5832-004.
-002
Log Data Error 2
 An encryption module not installed
1. Disable the log encryption setting with SP9730-004 ("0" is off.)
2. Install the DESS module.
-003
Log Data Error 3
 Invalid log encryption key due to defective NVRAM data
1. Initialize the HDD with SP5832-004.
2. Disable the log encryption setting with SP9730-004 ("0" is off.)
-004
Log Data Error 4
 Unusual log encryption function due to defective NVRAM data
Initialize the HDD with SP5832-004.
-005
Log Data Error 5
 Installed NVRAM or HDD which is used in another machine
1. Reinstall the previous NVRAM or HDD.
2. Initialize the HDD with SP5832-004.
Rev. 10/06/2010