SC Tables
SM Appendix 3-91 D023/D025
Appendix
Service Call
Conditions
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
919
CTL
D
External Controller Error 6
While EAC (External Application Converter), the conversion module,
was operating normally, the receipt of a power line interrupt signal from
the FLUTE serial driver was detected, or BREAK signal from the other
station was detected.
Power outage at the EFI controller
EFI controller was rebooted
Connection to EFI controller loose
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
920
CTL
D
Printer application error
An error is detected in the printer application program.
Defective software
Unexpected hardware resource (e.g., memory shortage)
1. Software defective; switch off/on, or change the controller firmware
if the problem is not solved
2. Insufficient memory
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
921
CTL
D
Printer font error
A necessary font is not found in the SD card.
A necessary font is not found in the SD card.
The SD card data is corrupted.
Check that the SD card has the correct data.
Rev. 10/06/2010
To Next Page
Loading...
