Ricoh D025 - Page 545

SC Tables
SM Appendix 3-93 D023/D025
Appendix
Service Call
Conditions
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
994
CTL
C
Operation panel management records exceeded
An error occurred because the number of records exceeded the limit for
images managed in the service layer of the firmware. This can occur if
there if there are too many application screens open on the operation
panel.
 No action required because this SC does not interfere with
operation of the machine.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
995 D CPM setting error
-001
 Defective BICU
 NVRAM Replacement error
1. Install the previous NVRAM.
2. Input the serial number with SP5811-004, and turn the main power
switch off/on.
-002
 Defective NVRAM
 Defective controller
1. Update the controller firmware.
2. Install a new NVRAM, and turn off and on the main power switch
after SC995-002 has occurred.
-003
 Incorrect type controller installed
 Defective controller
1. Replace the controller with the correct type.
-004
 Incorrect model controller installed.
1. Replace the controller with the correct model.
Rev. 10/06/2010