System Service Mode
D023/D025 8-38 SM Appendix
2105 [LD Power Adj.] (Process Speed, Color)
Adjusts the LD power of each color for each process speed.
Each LD power setting is decided by process control.
High Speed: 154 mm/sec, Middle Speed: 111 mm/sec,
Low Speed: 77 mm/sec
001 High Speed: Bk *ENG
002 High Speed: M *ENG
003 High Speed: C *ENG
004 High Speed: Y *ENG
005 Middle Speed: Bk *ENG
006 Middle Speed: M *ENG
007 Middle Speed: C *ENG
008 Middle Speed: Y *ENG
009 Low Speed: Bk *ENG
010 Low Speed: M *ENG
011 Low Speed: C *ENG
012 Low Speed: Y *ENG
[50 to 120 / 100 / 1%/step]
Decreasing a value makes lines thinner
on the output.
Increasing a value makes lines thicker
on the output.
2106 [Polygon Rotation Time]
Adjusts the time of the polygon motor rotation. DFU
001 Warming-Up *ENG
002 Job End *ENG
[0 to 60 / 10 / 1 sec/step]
To Next Page
Loading...
