Ricoh D025 - Page 743

System Service Mode
SM Appendix 8-147 D023/D025
Appendix
SP Mode
Tables
Repeat: Interrupt *ENG
[0 to 9 / 0 / 1 time/step]
007
Specifies the maximum number of repeats of the toner density adjustment during
printing. DFU
Toner Supply Coefficient *ENG
[0 to 25.5 / 10 / 0.1 sec/step]
008
Adjusts the time for the toner supply mode when a toner density is detected to be
low.
Consumption pattern: Bk *ENG
[0 to 255 / 5 / 1 time/step]
009
Specifies the belt mark generating time for checking the black toner density when
toner density is detected to be low at the toner density adjustment.
Consumption pattern: M *ENG
[0 to 255 / 5 / 1 time/step]
010
Specifies the belt mark generating time for checking the magenta toner density
when toner density is detected to be low at the toner density adjustment.
Consumption pattern: C *ENG
[0 to 255 / 5 / 1 time/step]
011
Specifies the belt mark generating time for checking the cyan toner density when
toner density is detected to be low at the toner density adjustment.
Consumption pattern: Y *ENG
[0 to 255 / 5 / 1 time/step]
012
Specifies the belt mark generating time for checking the yellow toner density
when toner density is detected to be low at the toner density adjustment.
T1 Bias: Bk *ENG
[0 to 80 / 20 / 1 µA/step]
013
Adjusts the image transfer belt bias for Black.
T1 Bias: M *ENG
[0 to 80 / 20 / 1 µA/step]
014
Adjusts the image transfer belt bias for Magenta.
T1 Bias: C *ENG
[0 to 80 / 22 / 1 µA/step]
015
Adjusts the image transfer belt bias for Cyan.