Ricoh D025 - Page 76

D023/D025 2-28 SM
4. Remove trays 1 and 2 of the machine.
5. Fasten the spring washer screw [D].
6. Reinstall all trays.
7. Attach the securing brackets [E] ( x 1 each; M4x10).
 One of the securing brackets is used as a securing tool (the cutout [F] is used
in step 5). But the cutout [G] is for attaching the tray heater. Therefore, attach
the securing brackets [E] after installing the tray heater if you install the tray
heater.
8. Load paper into the LCT.
9. Turn on the main power switch of the machine.
10. Check the LCT operation and copy quality.