Ricoh D025 - Page 787

System Service Mode
SM Appendix 8-191 D023/D025
Appendix
SP Mode
Tables
[Toner Collection Bottle Full Detection]
3800
Displays/ adjusts the toner collection bottle detection settings. These SPs are
used for NRS.
001 Condition *CTL
[0 to 4 / 0 / 1 /step]
002 Detection Times *CTL
[0 to 50 / - / 1 /step]
003 Print Page After Near Full *CTL
[0 to 1000 / 0 / 1 sheet/step]
004 Pixel Count After Near Full *CTL
[0 to 200000 / - / 1 cm
2
/step]
005
Pixel Count After
Replacement
*CTL
Displays the pixel counter after
replacement of toner collection bottle.
[0 to 200000 / - / 1 cm
2
/step]
008 Coefficient *ENG
[0.5 to 1.5 / 1 / 0.1 /step]
Notice Setting *ENG
Enables or disables the calling for
@Remote.
[0 or 1 / 1 / - ]
0: Enable @Remote calling
1: Disable @Remote calling
011
NOTE:
If the toner collection bottle has been replaced before the machine detects used
toner near full when this setting is set to "0", the machine cannot detect toner
collection bottle near full. In that case, set SP3-902-017 to "1".
Day Threshold: Toner
Collection bottle:NF
*ENG
[1 to 30 / 5 / 1 day/step]
012
Sets the threshold days for the near-full display. The near-full of the toner
collection bottle is displayed after the toner collection full sensor has detected
the actuator in the toner collection bottle.