shooting
Error Description Action
241.12
Second pick from manual feeder, tray
1, or feeder failed when the media was
in the source while other sheets were
committed to the paper path.
Remove the tray and inspect the
media path for obstructions. Check
the pick rollers. Replace the pick
rollers if they are worn or clogged
with dust. (
p.4-3 "ACM Pick Tire
Roller Removal"). Also check the
wear strips and the manual feeder,
and replace if necessary.
241.16
Failed to feed from tray 1. Pages in the
paper path have been flushed to the
output bin.
241.17
MISIDENTIFIED SMALL GAP JAM.
Engine detected small gap at the
manual feeder sensor, attempted to
open the gap by stopping the feed rolls,
trailing edge was seen at the input
sensor, manual feeder sensor is no
longer covered.
241.19
Second pick attempted failed from Tray
1, no pages printed since calling a
241.10 or a prior 241.19.
242.00 Paper jam near tray 2.
Remove Tray 2 and inspect for
obstruction in the paper path. Check
the pick tires for wear or paper dust.
Replace if necessary. Check the
wear strips and replace if necessary.
242.01 Took too long to ramp up dc feed motor Check the connection with Tray 2.
(Lift the machine and re-set it on
Tray 2.) If the error persists, then
replace Tray 2.
242.08
Received lots of dc feed interrupts
before losing them
242.10 Second pick attempt failed from Tray 2
Remove Tray 2 and inspect for
obstruction in the paper path. Check
the pick tires for wear or paper dust.
Replace if necessary. Check the
wear strips and replace if necessary.
To Next Page
Loading...
