Ricoh M126 - Page 251

M126/M127/M128 6-46 SM
Error code Description Action
80C
Remote device failed to respond to
the CTC command.
 Select a lower ‘Max Speed’
value under Fax Send
settings.
 Adjust ‘Transmit Level’.
80D
Received too many requests from
remote end to repeat the previous
command sent.
 Check line quality.
 Adjust ‘Transmit Level’.
 Check if line conditions on
remote end will facilitate a
good connection.
80E
Functional limitation- Remote fax
device does not support G3 receive
capability.
No action needed. Issue with the
remote device.
811
Failed to detect a fax device at the
remote end.
 Verify MFD is answering to
fax call and not a voice call.
 Decrease value of ‘Rings To
Answer’ setting.
812
No more data rates available in V34
modulation scheme.
 Adjust to a lower modulation
scheme.
813
Timeout occurred after waiting too
long to receive a good frame.
 Adjust “Receive Threshold”.
814
Tried too many times at selected
speed using V34 modulation
scheme.
 Adjust ‘Transmit Level’.
 Adjust to a lower modulation
scheme.
815
Fax transmission was interrupted
due to power failure.
Troubleshoot the machine if error
persists. See “Modem / Fax Card
Service Check” in
“Troubleshooting”.
818
Fax transmission failed due to
insufficient memory to store scanned
image.
Adjust ‘Memory Use’ setting to
allocate more memory for send
jobs.