Ricoh M126 - Page 253

M126/M127/M128 6-48 SM
Error code Description Action
886
Failure to transmit training
successfully in V29 terminal
modulation scheme.
 Select a lower “Max Speed”
under Fax Send settings.
 Adjust the “Transmit Level”.
 Check line quality.
887
Failure to transmit training
successfully in V27 terminal
modulation scheme.
 Select a lower “Max Speed”
under Fax Send settings.
 Adjust the “Transmit Level”.
 Check line quality.
888
Failure to transmit training
successfully at 2400 bps in V27
terminal modulation scheme.
 Adjust “Transmit Level”.
 Check line quality.
889
Failed to connect at the minimum
speed supported by the machine.
 Adjust “Transmit Level”.
 Incompatible connection.
88A
Failed to connect using V.34
modulation scheme.
Check line quality.
Adjust to a lower modulation
scheme.
Adjust Transmit Level Receive
Threshold values.
901
No fax tones detected from remote
end.
 Verify destination phone
number.
 Verify that the remote fax is
authorized to receive faxes.
902 No dial tone detected.
 Check by enabling ‘Behind a
PABX’ setting.
 Check phone line.
 Check MFD modem
hardware.
903 Busy tone detected.
Check with remote end if
successive attempts fail.
904 Hardware error detected.
See “Modem / Fax Card Service
Check” in “Troubleshooting”.