7. Clamp the cables [A] to prevent them from sticking out.
8. Reinstall the controller board with the HDD.
9. Remove the 1st and 2nd blank key tops.
10. Replace the blank key tops with the key tops received in the kit from top to bottom:
• 1st Copy
•
2nd Document Server
After Installing the HDD
1. Do SP5-832-001 to format the hard disk.
2. Do SP5-853-001
to copy the preset stamp data from the firmware to the hard disk.
3. Do SP5-846-040 to copy the address book to the hard disk from the controller board.
Hard Disk (D594)
147
To Next Page
Loading...
