10. Remove the controller cover [A] ( x1), and then cut out the cover for the USB-A slots.
11. Attach the upper left cover [A] to the mainframe ( x 2).
12. Reattach the controller cover ( x 1).
13. Connect the USB cable [B] to USB-A as shown above.
14. Plug in and turn on the main power switch.
15. Change the setting of Printer SP1-013-002 from "0" to "1".
16. Change the setting of Printer SP1-110-002 from "0" to "1".
17. Exit the SP mode, and then check the operation of the USB2.0/SD Slot.
USB2.0/SD Slot Type H (D594)
159
To Next Page
Loading...
