A: Leading Edge Registration (3 ± 2 mm)
B: Side-to-side Registration (2 ± 1.5 mm)
1. Check the leading edge registration [A] for each paper feed station, and adjust them using
SP1-001.
Tray SP mode
Tray: Plain SP1-001-002
Tray: Thick 1 SP1-001-003
Tray: Thick 2 SP1-001-004
By-pass: Plain SP1-001-007
By-pass: Thick 1 SP1-001-008
By-pass: Thick 2 SP1-001-009
Duplex: Plain SP1-001-013
Duplex: Thick 1 SP1-001-014
2. Check the side-to-side registration [B] for each paper feed station, and adjust them using SP1-002.
Tray SP mode
By-pass SP1-002-001
Tray 1 SP1-002-002
Tray 2 SP1-002-003
Tray 3 (Optional PFU tray 1 or LCT) SP1-002-004
Tray 4 (Optional PFU tray 2) SP1-002-005
Duplex (side 1) SP1-002-006
Blank Margin
• If the leading edge/side-to-side registration cannot be adjusted within the specifications, adjust the
leading/left side edge blank margin.
4. Replacement and Adjustment
272
To Next Page
Loading...
Need help?
General