Ricoh OR-C1 - Page 461

No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
- -
• Loose connection
• Defective HDD
•
Defective controller
- -
1. Check that the HDD is correctly connected to the controller.
2. Replace the HDD.
3.
Replace the controller.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
823 B
Self-diagnostic error: NIB
[XXXX]: Detailed error code
[6101]
MAC address check sum error
The result of the MAC address check sum does not match the check sum stored in
ROM.
[6104]
PHY IC error
The PHY IC on the controller cannot be correctly recognized.
[6105]
PHY IC loop-back error
An error occurred during the loop-back test for the PHY IC on the controller.
- Replace the controller.
No. Type Details (Symptom, Possible Cause, Troubleshooting Procedures)
824 C
Self-diagnosis error: Standard NVRAM
The controller cannot recognize the standard NVRAM installed or detects that the
NVRAM is defective.
[1401]
• Loose connection
• Defective standard NVRAM
• Defective controller
1. Check the standard NVRAM is firmly inserted into the socket.
2. Replace the NVRAM.
3.
Replace the controller
Service Call Conditions
103
3