1 Fusing Idling
Switches fusing idling on/off.
[0 = Off / 1 = On / 2 = Off plus machine
temperature check]
Switch on if fusing on the 1st and 2nd copies is
incomplete (this may occur if the room is cold.)
2
Reload Permit Setting:Reload
Temp.:Center
Adjusts the reload temperature at the center and
both ends of the hot roller when the temperature
inside the machine is 17°C or higher.
[100 to 150 / 130 / 1°C/step]
3
Reload Permit Setting:Reload
Temp.:Ends
4
Reload Permit Setting:Reload
Temp.:Cold:Center
Adjusts the reload temperature at the center and
both ends of the hot roller when the temperature
inside the machine is 16°C or lower.
[100 to 150 / 130 / 1°C/step]
5
Reload Permit Setting:Reload
Temp.:Cold:Ends
1105* Fusing Temperature Adjustment
1 Roller Center:Plain1 Adjusts the fusing temperature at the center and
both ends of the hot roller for plain paper 1.
D120/D139:[120 to 200 / 155 / 1°C/step]
D121/D122/D140/D141:[120 to 200 /
165 / 1°C/step]
2 Roller Ends:Plain1
3 Roller Center:Plain2 Adjusts the fusing temperature at the center and
both ends of the hot roller for plain paper 2.
D120/D139:[120 to 200 / 160 / 1°C/step]
D121/D122/D140/D141:[120 to 200 /
170 / 1°C/step]
4 Roller Ends:Plain2
5 Roller Center:M-Thick Adjusts the fusing temperature at the center and
both ends of the hot roller for middle thick
paper.
D120/D139:[120 to 200 / 165 / 1°C/step]
D121/D122/D140/D141:[120 to 200 /
175 / 1°C/step]
6 Roller Ends:M-Thick
System SP Tables-1
127
To Next Page
Loading...
