7 Thick Paper - Roller Center Adjusts the additional temperature for the center
and both ends of the hot roller for thick paper.
D120/D139:[ 0 to 40 / 25 / 1°C/step]
D121/D122/D140/D141:[0 to 40 / 20 /
1°C/step]
8 Thick Paper - Roller Ends
9 Center Minus:Thin Adjusts the subtract temperature for the center
and both ends of the hot roller for thick paper.
[0 to 20 / 5 / 1°C/step]
10 Ends Minus:Thin
11 Energy Saver
Adjusts the fusing temperature at the center and
both ends of the hot roller for energy saver
mode.
D120/D139:[ 0 to 200 / 135 / 1°C/step]
D121/D122/D140/D141:[0 to 200 / 145 /
1°C/step]
12 Wait Temp: Center Minus Adjusts the subtract temperature for the center
and both ends of the hot roller in stand-by
mode.
[0 to 30 / 5 / 1 °C]
13 Wait Temp: Ends Minus
14 After Warming-up Time
In this machine, fusing temperature is kept 10°C
higher than the normal temperature for a short
while after the machine warms up. This SP
selects the length of time that this temperature is
used.
[0 to 180 / 12 / 1s/step]
15 After Warming-up - No. of Page
In this machine, fusing temperature is kept 10°C
higher than the normal temperature for a
number of pages after the machine has warmed
up. This SP selects the number of pages made at
this temperature.
[0 to 10 / 3 / 1 page/step]
16 Low:Center Add:Plain Adjusts the additional temperature for the center
and both ends of the hot roller for printing on
thin paper/plain paper 1/plain paper 2/
middle thick paper when the temperature inside
the machine is 16 °C or lower.
[0 to 30 / 5 / 1 °C]
17 Low:Ends Add:Plain
4. Appendix: Service Program Mode Tables
128
To Next Page
Loading...
