2927*
ID Sensor Control
Selects whether the ID sensor is used or not for toner density control.
[0 = No / 1 = Yes]
If this value is "0", dirty background may occur after the machine has not been used for
a long time.
2928
Toner End Clear
Clears the toner end condition. Press Execute on the touch panel to clear the toner end
condition without adding new toner.
When you press Execute, the following are cleared:
•
Toner end indicator (goes out)
•
Toner near-end counter
• Toner near-end level
When making a lot of copies after changing this setting to "1", the carrier may be
attracted to the drum when the toner runs out, which may damage the drum.
2929* Vref Adjustment
1
Upper Limit
Adjusts the upper limit for Vref. [0.5 to 3.5 / 3.10 / 0.05 V/step]
2
Lower Limit
Adjusts the lower limit for Vref. [0.5 to 3.5 / 1.40 / 0.05 V/step]
2930*
TD Sensor Manual Setting
Adjusts the TD sensor output.
[0 to 5 / 0.0V / 0.05V/step]
2931*
TD (V/wt%) Setting
Adjusts the TD sensor sensitivity (coefficient: S) for toner density control.
[0.01 to 1.50 / 0.4 / 0.01/step]
4. Appendix: Service Program Mode Tables
152
To Next Page
Loading...
