1
Warming-up
If the period of time specified here elapses before the machine returns to full operation
from the energy saver or auto off mode, ID sensor warming-up is performed.
[0 to 999 / 480 / 1 min]
2
Number of Pages
The machine makes an ID sensor pattern after the specified number of prints has been
made.
[0 to 999 / 300 / 1 sheet/step]
3
Job End/Interrupt
Determines when the ID sensor reads the ID sensor pattern.
[0 or 1 / 0 / -]
0: Job End. Read pattern at job end.
1: Interrupt. Read pattern at interval set with SP2995-2, even if the job is not
completed.
2996*
Transfer Roller Cleaning
These SP codes determine how the transfer roller is cleaned.
1
0:OFF 1:ON
Selects whether the transfer roller is cleaned. Transfer roller cleaning is necessary only
when black spots occur in the image areas of copies. This can occur when bad
environmental conditions increase the toner density.
Set this to "1" when dirty background appears on the reverse side of the first page of a
copy job. However, the first copy time will be longer regardless of the SP2996 001
setting.
[0 = No / 1 = Yes]
4. Appendix: Service Program Mode Tables
154
To Next Page
Loading...
