3. Press the [Suspend / Resume] key to restart the print.
• You can suspend copying or printing only when the finisher shift tray is selected as the output tray.
Removing prints from Finisher SR5070 or Booklet Finisher SR5080 during printing
This section describes how to suspend a print job when using the finisher.
Depending on the image you are printing, prints might not stack properly. If this happens, suspend the
job, remove the prints and then restart the job.
1. Press the [Suspend / Resume] key.
1. [Suspend / Resume] key
2. Remove the stack of paper from the finisher shift tray.
3. Press the [Suspend / Resume] key to restart the print.
• You can suspend printing only when the finisher shift tray is selected as the output tray.
2. Getting Started
34
To Next Page
Loading...
