Solution:
This solution only works when the thickness of the paper is equivalent to Paper Weight 4 or higher. Do
not try this as a solution when using paper with a thickness equivalent to Paper Weight 3 or lower, as it
may cause paper misfeeding.
Adjusting the Current Applied to the Leading Edge of the Paper
1. In [Detailed settings] for the custom paper you are using, select 1216: [Paper Transfer
Output Correction: Paper Edge].
• 1216-01: Paper Transfer Output Correction: Paper Edge: BW: Leading Edge
• 1216-06: Paper Transfer Output Correction: Paper Edge: FC/FCS: Leading Edge
• 1216-11: Paper Transfer Output Correction: Paper Edge: S: Leading Edge: Clear/Special
• 1216-12: Paper Transfer Output Correction: Paper Edge: S: Leading Edge: White
• 1216-13: Paper Transfer Output Correction: Paper Edge: S: Leading Edge: Metallic
2. Adjusting the paper transfer current.
• If the paper transfer current is insufficient, increase the value by one step.
• If the paper transfer current is excessive, decrease the value by one step.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Start over from Step 2.
In case of excessive paper transfer current, if the problem persists even after decreasing the value
to the lower limit, there is no other solution.
In case of insufficient paper transfer current, if the problem persists even after increasing the value
to the upper limit, go to the next step.
4. Select 1216: [Paper Transfer Output Correction: Paper Edge], and then increase the value
in the following corresponding settings by "5 mm".
• 1216-02: Paper Transfer Output Correction: Paper Edge: BW: Leading Edge Length
• 1216-07: Paper Transfer Output Correction: Paper Edge: FC/FCS: Leading Edge Length
• 1216-15: Paper Transfer Output Correction: Paper Edge: S: Leading Edge Length: Clear/
Special
• 1216-16: Paper Transfer Output Correction: Paper Edge: S: Leading Edge Length: White
• 1216-17: Paper Transfer Output Correction: Paper Edge: S: Leading Edge Length: Metallic
5. Print the image. Has the problem been resolved?
Yes Finished!
Unprinted
113
To Next Page
Loading...
