No Go to the next step.
6. Set Energy Saver mode and other energy-saving modes to "Off".
7. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
8. Replace ITB Cleaning Unit.
For details, see "98 ITB Cleaning Unit", Regular Maintenance Guide.
9. Print the image. Has the problem been resolved?
Yes Finished!
No No further improvement is likely. Contact your service representative.
Stains at the Edge of the Paper
Cause:
There may be various factors.
Solutions:
1. If the paper is not registered as custom paper, register the brand of the paper.
2. In [Detailed settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then increase the value in the following corresponding settings by
5°C.
• 1232-01: Fusing Temperature: BW/FC/FCS: Heat Roller Temp
• 1232-06: Fusing Temperature: FCS: Heat Roller Temp: Clear/Special
• 1232-07: Fusing Temperature: FCS: Heat Roller Temp: White
• 1232-08: Fusing Temperature: FCS: Heat Roller Temp: Metallic
• 1232-26: Fusing Temperature: S: Heat Roller Temp: Clear/Special
• 1232-27: Fusing Temperature: S: Heat Roller Temp: White
• 1232-28: Fusing Temperature: S: Heat Roller Temp: Metallic
• 1232-46: Fusing Temperature: BW/FC/FCS: Fuser Setting HQ: Heat Roller Temp
• 1232-51: Fusing Temperature: FCS: Fuser Setting HQ: Heat Roller Temp: Clear/Special
Dirtied Printouts
53
To Next Page
Loading...
