• 1214-13: Paper Transfer Output: S: Side 1: Clear/Special
• 1214-14: Paper Transfer Output: S: Side 1: White
• 1214-15: Paper Transfer Output: S: Side 1: Metallic
• 1214-17: Paper Transfer Output: S: Side 2: Clear/Special
• 1214-18: Paper Transfer Output: S: Side 2: White
• 1214-19: Paper Transfer Output: S: Side 2: Metallic
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
4. In 1214: [Paper Transfer Output], further adjust the values in the applicable settings in
steps of ±1.
5. Print the image and check if there are any problems such as faintness or white spots.
Yes No further improvement is likely.
No Finished!
• Select "Clear/Special" when using Neon Yellow, Neon Pink, or Invisible Red. Select "Metallic"
when using Gold or Silver.
Horizontal Streaks of Uneven Density (Low-Resistance Paper)
When printing is performed on low-resistance paper such as metallic paper or black paper, horizontal
streaks of uneven density appear in the area approximately 85 mm (3.3 inches) from the trailing edge
of the paper.
5. Image Quality Problem: Lines/Streaks
156
To Next Page
Loading...
